XRY-2A Regenerative Coefficient Tester

XRY-2A Regenerative Coefficient Tester

Introduction

The instrument can be measured simultaneously in one test out different coefficients of thermal storage moisture state of the material, thermal conductivity, thermal diffusivity and specific heat, the device is simple, accurate, fast test (a test about ten minutes), References: JGJ51-2002 (lightweight aggregate concrete technical specification) and the like. In non-steady heat conduction based on the principle, heat it up briefly in the experimental material, the temperature of the test material is changed, according to the characteristics of the change, by solving differential equations of heat conduction, heat storage coefficient can be calculated test material, thermal conductivity , thermal diffusivity and specific heat.

Feature:

In non-steady heat conduction based on the principle, heat it up briefly in the experimental material, the temperature of the test material is changed, according to the characteristics of the change, by solving differential equations of heat conduction, heat storage coefficient can be calculated test material, thermal conductivity , thermal diffusivity and specific heat.

Technical Parameter

1, Application:

This instrument applies to the determination of homogeneous plates, gum, powdered, granular material thermal conductivity, heat storage coefficient, thermal diffusivity and specific heat drying or under different moisture condition. Heat storage material to be measured coefficients range 0.1-30W / M2K.

2, Sample size: a thin specimen 20 × 20 × (1.5 ~ 3) cm

Thick specimens two 20 × 20 × (4 ~ 10) cm

3, Power supply ~ 220V, 50HZ

4, Dimensions (L × W × H) 600 × 440 × 720 (mm)

5, working conditions

    ambient temperature 10 ~ 35 ℃

   Relative humidity ≤80%

   room temperature for stability ≤ ± 1.5 ℃

6, the accuracy of the measurement results of ± 5%

7, PC connection, and computer automated test, data printout.